Polyurethane Floor Sealer
Price Match Guarantee
Next day delivery*
30 Day trade accounts
Florex PU is a totally impervious hard wearing floor sealer. The polyurethane formula will adhere to almost any substance including concrete. This versatile concrete floor sealer will reduce porosity while providing a dustproof surface. Can also be used for walls. Comes with either a matt, satin or gloss finish.
Flortex® PU Twin Pack has been created to provide a totally impervious hard wearing floor sealer. The polyurethane formulation will adhere to a wide range of substrates including walls and floors, and will reduce porosity whilst providing a dustproof surface. The coating is not only UV light resistant but is also extremely easy to clean. Impact and abrasive resistance clear surface sealer. Resistant to hot water. Good chemical resistance.
Pot life: 60 minutes @ +20°c
Application temperature: 10°c-25°c
Re-coat time: 16 hours and (max.) 36 hours
Curing time: The area should be kept free of light traffic for 16 hours, and medium traffic for 48 hours. Full strength is achieved after 7 days.
Coverage: approx 30m² per 5kg unit
Number of parts supplied: 2
Priming required: Porous surfaces should be primed with WD Primer
Please consult the technical data sheet for full technical product data.
Surface Preparation
THOROUGH SUBSTRATE PREPARATION IS ESSENTIAL.
Surfaces to be coated must be clean, dry and free of loose contaminants. Air temperature minimum 5°C, maximum 30°C, humidity 70% RH maximum. Ensure good drying conditions prevail throughout the application and cure of the product.
Mixing
Having fully prepared the substrate, stir the individual components before mixing together.
Add Part ‘B’ to Part ‘A’ and thoroughly mix for at least 3 minutes. For best results use a heavy duty slow speed drill with a mixing paddle. Care must be taken when mixing to ensure that the hardener is properly dispersed.
ENSURE THOROUGH MIXING AS AN UNMIXED PRODUCT WILL RESULT IN A POOR OR NON-CURE SITUATION.
Application
Flortex® PU Twin Pack Gloss can be applied by brush or medium pile roller at an approximate thickness of 200-250 microns per coat. Two coats are recommended. If it is intended to apply two coats, the second coat should be cross-rolled, (applied 90 degrees to the first). Therefore, to have two people applying at the same time can make the application process faster and easier. The second applicator will need a pair of spiked shoes (available from Polycote) in order to be able to stand on/walk over the first coat. Ensure that material is applied evenly.
Application Temperature
Normal application temperature is between 10˚C and 25˚C. Surface temperature must be above 5°C. Where possible it is recommended that the application area is heated to a minimum temperature of 15°C for 24 hours prior to application to allow the ambient and substrate temperature to stabilise prior to installation. The maximum relative humidity should be 75%.
We promise to beat any quote in the UK when quoting like for like.
