Hyglaze WD

Self priming, high solid content, water-dispersed epoxy wall coating – easy application by roller.

  • Non toxic or taint, solvent free epoxy
  • Adheres to damp surfaces
  • Resistant to pressure washing
  • Does not allow fungus and mould growth
  • Available in 5kg units

£106.90 (ex VAT)

SKU: N/A
Please select required options below:
5kg
5kg
black
Black
buff
Buff
cream
Cream
dark-grey
Dark Grey
deep-red
Deep Red
light-blue
Light Blue
mid-blue
Mid Blue
mid-green
Mid Green
mid-grey
Mid Grey
white
White
yellow
Yellow
Clear

Please note: Actual product colour may vary from the images shown.

Hyglaze WD Product Details

A self-priming water-dispersed epoxy coating with a high solid content, providing a totally sealed, easy cleaned surface resistant to oils and liquids.

The formulation includes high build fillers to increase the film thickness and provide good abrasion and chemical resistance.

Easy application by roller
Two coats normally required
Available in 6 standard colours: others on request.

Number of parts:2
Application temperature:10oC – 30oC
Pot life @ 20oC:Up to 1.5 hours
Initial curing:16 – 24 hours
Re-coat time:24 – 48 hours
Coverage: 30 – 40m2 per 5kg unit
Number of coats:2
Priming:Self-priming

Please consult the technical data sheet for full product technical data.

Preparation:
Thorough substrate preparation is essential.
All loose friable or flaking material must be removed, and the surface must be clean, dry and free of dust.
Any oil or grease should be removed.

Mixing:
Having fully prepared the substrate, stir the individual components before mixing together. Add Part ‘A’ to Part ‘B’ and thoroughly mix for at least 3 minutes.
For best results use a heavy duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.

Application:
Apply by brush or roller, making sure that the surface is completely covered. Particular attention should be given to any protrusions or other vulnerable areas. When finished, DO NOT scrape the remaining contents from the container as this will invariably include unmixed raw resin.
A second coat of Hy-Glaze™ WD should be applied after initial curing has taken place – approximately 16-24 hours.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.