External Floor Paint – Slip Resistant

Number of parts:1
Application Temperature:Above 5oC
Drying time:4 – 6 hours
Recoatable:After drying overnight
Coverage:5L – 30-40m²
Number of coats:2

Please consult the technical data sheet for full technical product data.

Preparation:Thorough substrate preparation is essential.The surface must be clean, dry and free from dirt, grease and other contamination. New concrete should be left for at least 3 months before painting, and a moisture check should be carried out to ensure this lies within acceptable limits. Hard concrete or granolithic surfaces should be treated with Polycote Etch IT to improve adhesion, and any surface grease or contamination chemically removed using Polycote Degrease IT. These treatments must be thoroughly rinsed off and the surface allowed to dry before painting. Pits and holes may be filled using Polycote Cretex products. Please refer to relevant Data Sheets.

Mixing:Stir thoroughly before use to ensure full dispersion of solids throughout the mix.

Application:
Apply by roller or brush. If the area has not previously been treated, thin the first coat with 10% White Spirit to improve penetration and adhesion working well into the surface. Apply full second coat. On previously sealed floors apply two full coats. On previously painted surfaces one full coat may provide adequate coverage.
Avoid applying too thickly – two normal coats produce a far better result than one thick one, which may hinder the drying out.