HyGlaze Bund Coat

Surface Preparation
THOROUGH SUBSTRATE PREPARATION IS ESSENTIAL.
Prior to application of Hy-Glaze™ Bund Coat, the surface should be primed with Polycote EP Primer or WD Primer, depending on the type of substrate. Please contact Polycote Technical Helpline and prepare the surface in accordance with the appropriate primer Data Sheet. Should the time lapse between priming and top coat exceed 48 hours, abrade the primer to ensure intercoat adhesion
Mixing
Prior to mixing, both components should be kept at a temperature between 15°C and 20°C.
Having fully prepared the substrate, stir the individual components before mixing together. As pigment may ‘sink’, ensure that the mixing is very thorough and from the bottom of the container.
Add the hardener to the coloured resin and thoroughly mix for at least 5 minutes. For best results use a heavy duty slow speed drill with a mixing paddle.
Application
Apply by brush, roller or squeegee, making sure that the surface is completely covered. Always ensure a constant wet edge and work within the pot life of the material.
Make sure the coating is not overlapped in any area and apply in one direction only. Two coats are recommended in areas of high chemical aggression. The ambient temperature of the areas should not fall below 10°C throughout the application and curing period.
Application Temperature
Normal application temperature range is between +15°C and +20°C.
The maximum substrate and atmospheric relative humidity should be 75%.