Flortex UVR

Flortex UVR is a low viscosity two part high build 100% solids polyurethane formulation providing an extremely tough and totally impervious gloss finish with excellent chemical resistance that is UV stable. Its low viscosity formulation ensures maximum penetration into porous surfaces, actually strengthening the substrate.
If you need a completely clear, non-yellowing UV resistant coating, Flortex UVR is the answer.This is a 100% solids twin pack high build clear coating, that is not only incredibly tough, but will ensure a light-stable protective seal to your surface. Flortex UVR has superb flexibility, making it the ideal choice for timber floors and structures.
Coverage: 5L – 20-25m²
Typical Uses:Flortex UVR is the ideal choice for timber floors, walls, hand rails, steps, stairs, ramps, decking and furnishings.

Pot life:20 mins @ 20oC
Application temperature:10oC – 25oC
Initial curing time:8 – 12 hours
Fully cured time:7 days
Recoat time:12 – 24 hours
Number of parts supplied:2
Priming required:No – however we recommend two coats

Please consult the technical data sheet for full technical product data.

Preparation:Thorough substrate preparation is essential.Recommended methods are:Powerfloated, loose or friable concrete – use a Vacuum Assisted Shotblaster to remove weak laitance and provide a surface key for the coating. If this is not possible, chemically etch with Polycote Etch IT then rinse thoroughly and allow to dry.Loose paint or rust – remove, using a Vacuum Assisted Shotblaster, Floor Grinder or equivalent method.Oil or grease – use Hot Compressed Air for large areas of contamination.Smaller, isolated deposits may be chemically cleaned with Polycote Degrease IT then rinsed thoroughly and allowed to dry. See relevant Data Sheet prior to application.Once prepared, the area must be kept clean and free of traffic.

Mixing:
Thoroughly agitate Parts ‘A’ and ‘B’ individually to disperse any settlement, then add hardener Part ‘B’ to resin Part ‘A’ and mix for at least two minutes using a heavy-duty slow speed drill with a mixing paddle. Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.

Application:
Once mixed, the Flortex UVR must be applied immediately.Apply by brush or roller, maintaining an even application.The ambient temperature must remain above 10oC and the surface temperature above 5oC during the application.